© Polinet S.r.l.
-
Jammer 4 Bande di telefoni cellulari e di telefoni senza fili 
-

Il Jammer PLM-043-4B 

Il PLM-043-4B, è il nullificatore per telefoni cellulari in quanto li rende inutilizzabili non facendo vedere “campo” ai telefoni senza fili e cellulari operanti sulle gamme:

• GSM 900 MHz
• GSM 1800 MHz
• DECT
• DCS 1900 MHz
• WIRELESS PHONES 960 MHz
• UMTS
• WI-FI & BLUETOOTH
• VIDEO SENDER 2.4 GHz
-
the PLM-043-4B Cellular Communications Jammer, totally paralyses, rendering inope-rable all kind of mobile and portable phones working in the bands:
• GSM 900 MHz
• GSM 1800 MHz
• DECT
• DCS 1900 MHZ
• WIRELESS PHONES 960 MHz
• UMTS
• WI-FI & BLUETOOTH
• VIDEO SENDER 2.4 GHz

L’effettivo raggio di azione del dispositivo dipende dalla distanza della stazione radio base al PLM-043-4B (vedi diagramma qui sotto) e del telefono cellulare al PLM-043-4B.

Il raggio di azione tra PM-043-4B e telefono cellulare quindi puo’ essere da 7 mt. (min.) con segnali molto forti ad oltre 100 mt in condizione di deboli segnali della stazione radio base.

Il dispositivo include: alimentatore interno AC Switch mode 110-240 VAC o alimentazione DC esterna (commutabile), controllo remoto tramite GSM detector esterno collegabile “Plug and Play”.
Il nullificatore sarà azionato automaticamente dall’esterno posizionando su REM il commutatore frontale e collegando il GSM detector “PLM-GSM-GPRS DETECTOR” (non incluso) sul connettore REM presente sul frontale.

In modalità manuale, il PLM-043-4B viene acceso manualmente posizionando su “LOC” il commutatore frontale.

Un altro commutatore permette di scegliere tra la potenza di uscita piena o ridotta  (circa ½ potenza) (HI / LOW).

The radius of effective mobile phone paralysis depends on the distance of the cellular base station antennas from the position of the PLM-043-4B (see diagram attached) and cellular phone.

This paralysis radius is between 7 mt. (min.) with strong Base station signals minimum to over 100 mt. in weak base station signals.

Included AC Switching internal Power Supply 110-240 VAC or DC ext in (switchable), GSM detector / remote control in “Plug & Play” interface to switch On / Off the jammer from remote.

The jammer will be automatically switched On by the external GSM detection unit “PLM-GSM-GPRS DETECTOR”.

When the PLM-043-4B edition is set on “REM” function, the jammer will be able to be controlled by the external GSM detection device DMC not included (see “PLM-GSM-GPRS DETECTOR” data sheet) or a wired remote control.
Another switch select HI / LOW RF Power out.
(Full Power or reduced to ½).
 

Vendita esclusivamente ad enti governativi !
Per ulteriori informazioni telefona al: 06-87.23.03.58
 



-
1)Short antenna is for 940 MHz band
2) Long antenna    is for 1850 MHz band 
-
Lo studio di nuove antenne omnidirezionali ad alto guadagno a larga banda con connettori “N”, l’aggiunta di un misuratore di potenza per la banda 940 e la banda 1800 MHz  visualizzabile tramite strumento ad ago, che permette di monitorare continuamente la funzionalità degli amplificatori di potenza interni, inoltre un sistema di generazione del disturbo ottimale per il sitema GSM, fanno del PLM-043-4B , un apparato dalle caratteristiche ottimizzato rispetto alle precedenti versioni. 

The new omnidirectional, wide band, high gain, “N” connectorized antennas plus the dual band rf power analog meter , just to test the two different power amplifiers inside, and the  optimized technology of the GSM noise jamming generator, make the PLM-043-4B  a performing and modern equipment in comparison to the older versions.

--

-
Lo chassy è stato studiato con filtri di rete per consentire una protezione delle elettroniche interne e dell’alimentatore stesso dalla potenza irradiata dal jammer e da eventuali altri apparati similari che lavorano nelle immediate vicinanze.

Inoltre l’apparato è stato sottoposto a misure di campo irradiato per verificarne la rispondenza ai limiti consentiti per la salute umana.

I valori di 18 V/ metro in gamma 940 MHz e di 25 V/ metro misurati a soli 5 cm. Di distanza dalle antenne del PLM-043-4B, dimostrano di rispettare anche i limiti tassativi introdotti dalle normative ANSI-1982, NATO-1979, IRPA-1982 e URSS-E1970.
-
The special aluminium chassy and the AC plug are EMI filtered and were designed to protect the internal power supply and electronics against rf standing waves and other possible similar equipments working around.
-
At the same time the PLM-043-4B is compatible with the permitted electrical field strength limits in the western world for the human health.
-
The value of 18 V/meter @ 940 MHz and 25 V/meter @ 1840 MHz are the  electric fields observed at 5 cm. distance from the 4 antennas.
The ANSI-1982, NATO-1979, IRPA-1982 and URSS-E 1970 specifications for short and long terms fields strength exposures limits are largely respected.

 

-

Caratteristiche Tecniche PLM-043-4B

Gamma di funzionamento:
Working frequency range: 920  -  960 MHz    +/-2   MHz
                                      1800 - 1900 MHz    +/-2   MHz
                                      2120 - 2180 MHz    +/-2    MHz
                                      2400 - 2500 MHz    +/-2    MHz
-
Potenza di emissione complessiva:
Total power output:         4 x 1,5W Out ? 1dB
-
Guadagno antenna:
Antenna gain:                 +1 db on 940 MHz band, +3db on 1800Mhz band 

Alimentazione interna:
P.supply AC :                    internal switch mode p.s. 110-240 VAC 25 W

Alimentazione esterna DC:
EXT DC IN: From external 11.5 – 13.8 DC, 2A nominal 
-
Assorbimento massimo in funzione :
Maximum absorption:       25 W
-
Tecnica generazione del jamming:
Principle of operation:       PN FM-W SWEEP.
-
Dimensioni:
Cabinet size :                   285 *135 *65 mm.
 -
Contenitore:
Cabinet:                          Milled Aluminium case, black anodized, wall mounting cover.
 -
Antenne incluse:
Antennas included:           1/4 lambda whip-dipole @ 940 MHz 125mm length; ½ lambda whip @ 1850 MHz 140mm length.       Both “N” connectors
-
 

ATTENZIONE: DATA LA PARTICOLARITA’ DEL PRODOTTO OCCORRE ALL’ORDINE LA DICHIARAZIONE DI UTILIZZO FINALE (END USER) DA PARTE DI CHI ACQUISTA
WARNING:  NEED “END USER DECLARATION” BY THE CUSTOMER.
 

Per ulteriori informazioni telefona al: 06-87.23.03.58

inviaci un fax al: 06 - 87.14.82.33